Prime tower? 8 by 3DTech Bambu Studio Bambu Lab Community Forum

Prime Tower Orca Slicer. Orca Slicer Tutorial Part 1 What to do with brand new filament YouTube Orca bot: this issue is stale because it has been open for 90. I have already managed to change the filament correctly with a pyrga tower, the only detail is that I cannot find a way to remove the additional purge, since it makes an extrusion on top of the purge tower, how can I remove that additional extrusion ?

Others: This section contains bed adhesion settings, prime tower. Unofficial space for Orca Slicer users to discuss settings, features and tips.

Prime tower? Bambu Studio Bambu Lab Community Forum

Looks good but there's a pretty huge tower, no need to waste so much Every object on the bed plate should move freely inside the print area defined But if you don't want to use it, in the 'others' section of the settings there's a toggle (in addition to the ability to set its size)

OrcaSlicer An Introduction and How to Get Started Obico Knowledge Base. Have used this setup with previous versions of orca without issue Every object on the bed plate should move freely inside the print area defined

OrcaSlicer An Introduction and How to Get Started Obico Knowledge Base. The Prepare tab does not take in to account the brim width of the Prime tower, but this doesn't should block the movement of the Prime tower. The height of the prime tower: Since the principle of time-lapse is to take a snapshot after each layer is printed, the nozzle needs to be wiped on each layer, so the height of the time.